I love the delicateness of this model. Thanks for sharing. And thanks a whole lot for modelling the drawers to be fully openable :-) You mention you don't know how to use contraints, so here goes ... You need a "Limit Location" constraint to make an object slide like a drawer. You can either apply the Limit Location directly to the drawer, or to an Empty and make the drawer a child of the Empty. The other method is to use a bone with a constraint. Or if animating, you can use key frames. The Limit Location and bone methods are briefly discussed on [http://blenderartists.org] (http://blenderartists.org/forum/showthread.php?323370-Limit-Location-being-a-pain!). I noticed you have the drawer fronts all as one object, so I separated them, renamed appropriately and Set Origin to Geometry on each (Blender set my origins at the front edges of the drawers). Then I set all the drawers flush with the the Main Frame. You can now add the Limit Location constraint but click the eye icon to disable it while you work out what figures to enter in the boxes. In the Transform panel, the Y Location for each (closed) drawer is 12.83176cm. You should pick one drawer, e.g. upper left, and work out how far you want it to come out, then note the new Y Location figure. I decided on -34.171cm. Leave the drawer out, hide the Studio Set and Area Light for a moment and go into Top Ortho view. When closed, the front of the drawer is located 12.83176cm "behind" the X axis, and when the drawer is pulled out fully it will extend to a point -34.17088cm "in front of" the X axis. The global Y axis extends from negative to positive, and therefore the figure for Minimum Y will be the "opened position" of -34.17088cm and the figure for Maximum Y will be the closed position. Now set the Y Location of the drawer back to 12.83176cm and activate the constraint. I will just give you my figures for the upper left drawer. + Location X = -69.86991cm + Location Y = 12.83176cm + Location Z = 1.43521m These are the corresponding figures for the Limit Location constraint (World Space): + Minimum X = -69.87cm + Maximum X = -69.87cm + Minimum Y = -34.171cm + Maximum Y = 12.832cm + Minimum Z = 1.435m + Maximum Z = 1.435m Now you can use the manipulator widget to pull out the drawer.

Dudes, you are getting really, really great at modeling this type of thing. I love your work.

Thank you :)